Braun 34443 - Manual (Page 46)

Page 44
SEAT REMOVAL AND INSTALLATION
Third Row Seats
Third row 60/40 split bench seats
have been modified during conver-
sion procedures. Seat backs can be
folded down to the flat position and
tipped forward to provide full access to
rear floor storage compartments. The
Stow ’n Go (stow in floor) feature is
not available.
Seat removal is allowed for the driver
side section of the seat (instructions
on opposite page). The electronic
control module assembly is mounted
under the passenger side section of
the seat. Removal of the passenger
side section of the seat is prohibited*.
* Should removal of the passenger
side section of the third row seat
be imperative, contact The Braun
Corporation at 1-800-THE LIFT
® .
A Braun Product Support represen-
tative will direct you to an authorized
service technician.
Folding (tipping) Third Row Seats
Seat backs can be folded down to
the flat position and tipped forward.
Seats must be returned to the full
stowed (locked) position before
driving.
To Fold (tip forward) Third Row
Seats
1. From the rear of the vehicle, fold
down the back of the bench seat
(pull release strap #1).
2. Pull the release strap at the rear
of the seat (between seat base
and floor), and lift and fold (tip)
the seat forward.
To Unfold (rotate rearward) Third
Row Seats
Carefully (slowly) rotate and lower
seat rearward to stowed position.
Ensure the rear spring-loaded at-
tachments engage floor strikers.
Raise the seat back (pull release
strap #1) and attempt to move
seat back and forth.
Caution: Use extra care when
lowering passenger side section
of seat. Do not slam seat down
or allow seat to drop (free-fall).
Doing so may result in damage
to the electronic control module
assembly.
WARNING
Install seats as
specified before
occupying seats or
operating vehicle.
Failure to do so may
result in serious
bodily injury and/or
property damage.