Black Box FX802A - Manual (Page 21)

23
CAMPUS PAGER
3. Make sure that the Campus Pager is turned ON, then enter a two-digit
pager code (00-99) and then 0.
4. Press the TRANSMIT button on the Campus Pager, and the unit will
transmit the pager code to the pager. The pager will beep four times, and
flash “L” on its display four times. The pager then beeps 12 times and
simultaneously flashes 0 on its display to confirm that it received the
message code 0.
NOTE
For example, if you would like the pager to have a new pager code such
as 38, enter 380, and press TRANSMIT.
After you press the TRANSMIT button, the Campus Pager LED flashes the
three digits seven times, and simultaneously transmits the pager code to the
pager. The three digits will stay lit until you perform one of the following
actions:
• Turn the Campus Pager OFF
• Press A/C or CANCEL
• Transmit a message to a pager
Perform the preceding steps for each pager used with the Campus Pager.
NOTE
If the pager does not successfully store the pager code, repeat the
preceding steps.
5.4 Transmitting a Message Code to a Single Pager
1. Turn the Campus Pager power ON.
2. Press A/C or CANCEL if the display shows unwanted pager or message
codes.
3. Enter the two-digit code for the pager you want to receive the message,
then the one digit message code that you want to send. If you enter the
wrong pager or message code, press A/C or CANCEL, then re-enter the
correct codes.