Black Box FX802A - Manual (Page 22)

24
CAMPUS PAGER
NOTE
You cannot reset either of these codes after you press the TRANSMIT
button.
4. Press the TRANSMIT button. The TRANSMIT display lights during
transmission, and the pager’s display flashes the message code number
seven times. The three digits will remain lit until you perform one of the
following actions:
• Turn the Campus Pager OFF
• Press A/C or CANCEL
• Transmit a message to a pager
If desired, press TRANSMIT again to re-send the current message code to
the pager.
5. Press A/C or CANCEL, then repeat Steps 3 and 4 if you want to transmit
another message code to another pager.
5.5 Transmitting a Message Code to All System Pagers
1. Turn the Campus Pager power ON.
2. Press A/C or CANCEL if the display shows unwanted pager or message
codes.
3. Press ALL, then the one digit message codes that you would like to send.
If you enter the wrong message code, press A/C or CANCEL, then re-
enter the correct code.
NOTE
You cannot reset the message code after you press the TRANSMIT
button.
4. Press the TRANSMIT button. The TRANSMIT display lights during
transmission, and the pager’s display flashes the message code number.
See Section 5.6. If desired, press TRANSMIT again to re-send the current
message code.
5. Press A/C or CANCEL, then repeat Steps 3 and 4 if you want to transmit
another message code.