Philips RI9828-47 - Manual (Page 24)

22
PROGRAMMING THE MACHINE
MACHINE SETTINGS
Activate/deactivate the warning to replace the water
fi lter.
Activate/deactivate the rinse function to briefl y clean the
internal circuits of the machine.
This function is activated by default by the manufacturer.
Note: the rinse cycle is performed every time the
machine is started up, after the warming phase.
This function allows you to set various water settings.
Adjust the machine's water hardness setting. This will
allow the machine to request descaling at the right time.
Measure the water hardness as shown on page 6.
water
settings
rinse
on
water fi lter
off
water
hardness
3/4
Important note.
This setting automatically adjusts the parameters which allow the
user to perform correct machine maintenance.
Select “on”: only when the water fi lter is installed in the water tank as
shown on page 7.
This function is automatically activated after selecting “reload water fi lter”.
Select “off”: when there is no water fi lter in the water tank.
Select “reload water fi lter” : when a new water fi lter is installed in the
water tank.
NOTE: if the water fi lter is not available, insert the small white fi lter
previously removed (see step 1 - page 7) into the tank.