Philips 10002518 - Manual (Page 13)

13
English
ment may only be noticed in this way. The references
located inside the coffee bean hopper indicate the grind
setting.
1 - Coarse Grind
2 - Medium Grind
3 - Fine Grind
5.2 Stand-by
The machine is designed for energy saving.
After 60 minutes of inactivity, the machine turns off au-
tomatically.
To turn the machine on again, simply press the power
button (17); in this case the machine will go through the
rinse cycle only if the boiler is cold.
5.3 Adjusting the Brewed Coffee
The machine allows you to adjust the amount of brewed
coffee according to your tastes and/or the size of your
coffee cup(s).
Each time you press and release the brew button (14)
or (15) the machine brews a pre-programmed amount
of coffee, which is different for each button. This amount
may be re-programmed to your taste. Each button may
be individually programmed for a specifi c brew setting.
As an example, the following procedure describes the
programming of button (14), which is normally associ-
ated with espresso coffee.
• (Fig.10) - Place a cup beneath the dispensing
spout.
• (Fig.12) - Press and hold down the brew button (14).
A green icon appears on the display:
• (Fig.12) - When the amount of coffee in the cup
reaches the desired level, release the brew button
(14).
This button (14) is now programmed; each time it is
pressed and released, the machine will brew the same
amount of coffee just programmed.
5.4 Dispensing Spout Adjustment
(Fig.9) - The height of the dispensing spout (4) may be
adjusted to better fi t the dimensions of the cups that you
wish to use.
Manually move the dispensing spout up or down to ad-
just its height.
The recommended positions are:
(Fig.10) - for use with small cups;
(Fig.11) - for use with large cups.
5.5 Aroma Adjustment
The machine allows you to adjust the amount of coffee
to be ground for each cup.
When you press and release the aroma button (18)
three selections are available (mild, medium, and
strong). The system sets the aroma according to your
personal taste.
Selection can be made when the beans appear on the
display. Each time the aroma button (18) is pressed and
released, the aroma changes by one step. Selection
must be made prior to brewing coffee.
6 COFFEE BREWING
Note: Should the machine not brew coffee,
make sure that the water tank contains
water.
Before brewing coffee, check the messages
on the display. Check that the water tank and
coffee been hopper are full.
• (Fig.10 - Fig.11) - Place 1 or 2 cups beneath the
dispensing spout (4). You may adjust the height of
the dispensing spout to your cups.
• Check that the machine is ready. At this point a green
icon should be displayed.
ADJUSTMENTS - COFFEE BREWING