Gradall 534B (9020-7317) Service Manual - Manual (Page 189)

-28-
Figure 159
Tap output and low clutch shaft to the rear. Install
rear bearing locating rings.
Figure 156
Position new gasket and “O” ring on rear of trans-
mission housing. A thin coat of chassis grease will
hold the gasket and “O” ring in place.
Figure 155
Install new oil sealing ring on low clutch shaft.
NOTE: New ring must be sized before installing low
shaft bearing cap.
Figure 154
Install low clutch rear bearing washer and retainer
r i n g .
Figure 157
Install rear cover, bolts and lockwashers.
Figure 158
Tighten bolts 37 to 41 ft. lbs. torque [50,2 - 55,5 N.m].