Orbelle Seat N Go - Manual (Page 2)

1. Turn the top seat (C) upside down and place it on the
floor as illustrated in the diagram.
2. Connect the legs (A), making sure that the left label
goes to the left side and the right label goes to the right
side of the seat.
3. Fasten them in place with the long screws (M). Don’t
tighten the screws all the way yet
4. Turn the bottom platform (B) upside down as illustrated
and slide it onto the legs. Make sure that the holes in
the legs align with the holes of the platform. Fasten
them with the short screws (N).
5. Re-check and tighten the screws to the top seat (C).
6. To attach the wheels (E), allign the two grooves at
the top end of the wheels with the square holes on
part A (L&R) and push them together until you
hear a click.
7. Choose the correct size and type of fitting to connect to
your pushchair (carriage). This depends on the shape and
size of the pushchairs (carriage) chassis (tubing). If the
pushchair (carriage) has square tubes then use the part (W),
which is already attached to part (D).
8. If the pushchair (carriage) has a round tube, then if necessary choose part (J) or (F)
depending on the diameter of the tube and insert them into part (Z).
Remove part (W) by
unscrewing the plastic tap screw and exchange it with part (Z).
-2-