Orbelle Seat N Go - Manual (Page 3)

9.
Connect part (W) or (Z) to the pushchair’s (carriage) tubing,
insert it into part (D) and tighten the plastic tap screw well.
These parts (D) should remain on the pushchair (carriage)
constantly.
10. To attach the Hitchhiker to the pushchair (carriage), press the
red buttons on both sides of the seat (C), insert the Nickel bars
(D) all the way until the end and release the red buttons to lock
them into place.
You must make sure that the
Nickel bars (D) are fully inserted and firmly
locked into place before use and
cannot be
pulled out
. If you wish to pull them out you must press the
red buttons again.
Adjusting the Hitchhiker
It is important that the Hitchhiker seat (C) is parallel to the floor. This can be done by connecting
part (W) or (Z) at the same height level more or less as the top seat (C). If the structure of the
pushchair (carriage) does not permit this, then you may connect them in any other suitable
location. You may need to adjust the angle of the egg shaped plastic fasteners on both sides of the
top seat (C) to enable the Nickel bars (D) to lock into them. This is done by removing the screws
at the side of the egg shaped fasteners, thus removing them completely from the seat and refitting
them back at the most appropriate angle.
The Hitchhiker should be placed as close as possible to the pushchair (carriage), depending on the
pushchair’s (carriage) structure and the comfort of the child. To set the distance from the
pushchair (carriage), loosen the screw on the plastic that holds part (D) into place, move the Nickel
bar (D) into 2 different grooves and tighten the screw. It is important that both the left and right
side are locked into the same grooves (same distance from the pushchair /carriage).
-3-