Steele Products SP-CE355AT - Manual (Page 11)

11
Owner’s Manual
Hazard Warnings (cont’d)
RISK OF INJURY (cont’d)
• Use only impact grade sockets on an impact wrench.
• Do not apply excessive force to the tool. Let the tool perform the work.
• Never point discharge of tool at self or others.
• Do not pull trigger unless tool contact safety device is against work surface.
• Never attempt to drive fasteners into hard surfaces such as steel, concrete, or tile
when using air tools.
• Use only accessories identified by the manufacturer to be used with specific tools.
• Maintain the tool with care.
• Keep a cutting tool sharp and clean .A properly maintained tool, with sharp cutting
edges reduces the risk of binding and is easier to control.
• Check for misalignment of binding or moving parts, breakage of parts, and any other
condition that affects the tool’s operation. If damaged, have the tool serviced before
using.
• Use of an accessory not intended for use with the specific tools increases the risk of
injury to persons.
• Always shut off the compressor, remove the plug from the outlet, and bleed all
pressure from the system before servicing the compressor, and when the
compressor is not in use.
• Do not operate the unit with the shroud removed.