Steele Products SP-CE355AT - Manual (Page 28)

28
Owner’s Manual
Compressor (cont’d)
TROUBLESHOOTING (cont’d)
Motor will not run (cont’d)
• Fuse blown or circuit breaker tripped
Replace blown fuse or reset circuit breaker. Do not use fuse or circuit breaker with
higher ratting than specified for your circuit.
Check for proper fuse; ”Fusetron” type T is acceptable.
Check for low voltage and proper extension cord size.
Disconnect other applications from circuit. Operate compressor on a dedicated circuit.
• Check valve, stuck open
Remove and clean or replace.
• Pressure bleeder valve on pressure switch has not unloaded head pressure
Bleed line by moving pressure switch lever to OFF position before restarting.
If bleeder valve does not open, replace bleeder valve.
• Wrong wire gauge in extension cord
Check for proper gauge and extension cord length.
• Paint spray on internal motor parts
Bring to service center for service. Do not operate compressor in the paint spray area.
• Possible defective motor
Bring to service center for inspection and repair.