Steele Products SP-PT253 User Manual
2 rotary combo kit
Advertising
Table of contents
Document Outline
- Safety Guidelines - Definitions
- General Precautions
- General Precautions (cont’d)
- General Precautions (cont’d)
- Additional Warnings
- Additional Warnings (cont’d)
- Additional Warnings (cont’d)
- Additional Warnings (cont’d)
- Additional Warnings (cont’d)
- Operation (cont’d)
- Inserting/Removing Accessories
- 1 Press the shaft lock button.
- 2 Rotate the shaft manually until the lock engages and prevents further rotation.
- 3 Use the wrench to loosen the collet nut by turning in the direction of the arrow labeled L in t...
- 4 Remove the old accessory (if any) and install the new accessory, being sure to push it as far a...
- 5 Tighten the collet nut by hand until snug.
- 6 Finish tightening the collet by turning the wrench in the direction of the arrow labeled T in t...
- Inserting/Removing Accessories
- Operation (cont’d)
- Operation (cont’d)
- Operation (cont’d)
- Using the Tool
- 1 Insert the correct accessory and tighten the collet nut securely.
- 2 Be sure to wear eye protection and any respiratory protection that may be required.
- 3 Mount or grasp the work piece securely, being sure to follow every precaution listed on pages 6...
- 4 Grasp the tool using either of the gripping methods shown here. The pencil grip (top) is best f...
- 5 Start the tool. If using the variable- speed tool, select the appropriate speed for the work yo...
- 6 Balance the accessory as described on the previous page.
- Using the Tool
- Operation (cont’d)
- Operation (cont’d)
- Operation (cont’d)
- Recommended Speeds
- Recommended Speeds (cont’d)
- Recommended Speeds (cont’d)
- Recommended Speeds (cont’d)
- Recommended Speeds (cont’d)