Steele Products SP-WE180 - Manual (Page 14)

14
End of Operation
When you have ?nished using the detergent injection system, continue to run in low-pressure position
and ?ush clean water through the detergent tank until it is thoroughly cleaned.
Note: Failure to clean properly will cause the injection system to become clogged and
inoperable.
• Stop the machine by pressing ON/OFF button
• Disconnect electrical plug
• Turn off water and depressurize unit by squeezing trigger.
Warning: Turn off water supply and squeeze trigger to depressurize the unit. Failure to
do so could result in personal injury due to discharge of high-pressure water.
• Disconnect the high-pressure hose and the water inlet hose.
Connections
Connections on pressure washer hoses, gun and spray wand should be cleaned regularly and
lubricated with non-water soluble grease.
Nozzle
The high-pressure/low-pressure adjustment of the nozzle should be lubricated with non-water soluble
grease regularly.
Clogging of the nozzle causes the pressure to be too high and cleaning is immediately required.
1. Make sure that the pressure washer is turned off and that the power cord is unplugged.
2. Make sure that the water supply is turned off, and that the trigger is squeezed to depressurize the
unit.
3. Separate the front-wand from the back-wand.
4. Clear the nozzle with tip cleaner.
5. Flush the nozzle backwards with water.
6. Reconnect the front-wand to the back-wand.
Reconnect and restart the pressure washer and depress the trigger on the spray gun. If the pressure
is still too high, repeat above items 1-4.
Operating Instructions
Maintenance