Steele Products SP-WE180 - Manual (Page 8)

8
High Pressure Hose (See Figure 1)
Remove and discard the water plug (Fig.1) before attaching the high-pressure hose by carefully
inserting the fitting with the o-ring into the high-pressure outlet and tighten threaded nut by hand. (Fig.1)
Water Connection (See Figure 2)
Before connecting run water through the garden hose (not supplied) to flush out any foreign matter.
Attach garden hose to the pressure water inlet connection. (Fig.2)
Power Supply Connection
The pressure washer is factory-equipped with an electrical outlet installed in accordance with local
safety regulations.
NOTE: The power supply must be 120v, 60Hz and a minimum 15amp circuit.
A Connect only to properly grounded outlet. Do not remove grounding pin.
B Inspect cord before using. Do not use if cord is damaged.
C Do not touch plug with wet hand.
D Keep all connections dry and off the ground.
E If replacement of the plug or cord is needed, use only identical replacement parts. Contact
Customer service for proper replacement parts.
Extension cords are not recommended unless they are plugged into a receptacle protected by a ground
fault circuit interrupter. Any extension cord used should be 14 AWG and no longer than 50’ to prevent
excessive voltage loss. Use only extension cords intended for outdoor use. These extension cords are
identified by a marking “Acceptable for use with outdoor appliances; store indoors when not in use”.
High-pressure
Hose connector
High-pressure hose
Fig. 1
Installation
Fig. 2
Garden hose
Washer
Quick connector
Machine Inlet