SkyTrak 10042 Operation Manual - Manual (Page 37)

Operation
35 Model 10042 Rev. 11/03
Seat Belt
IMPORTANT! Inspect the seat belt every time it is used, looking for cut or
worn webbing, or any defect in the latch assembly. If any wear or damage is
noted, DO NOT operate the vehicle until the seat belt is replaced.
Before the engine is started, adjust the seat as required for position and
comfort. Then adjust the seat belt as follows:
1. Grasp both free ends of the belt and make certain that the belt web-
bing is not twisted or entangled in any portion of the seat assembly.
2. With your back straight in the seat, couple the retractable end or the
male end of the belt into the receptacle (buckle) end of the belt.
3. With the belt buckle as low on your body as possible, pull the
retractable end of the belt or the free end of the belt away from the
buckle until it is tight across the lap.
4. To release the belt latch, depress the red button (1) or lift the black
cover (2) of the buckle (dependant on belt style installed), and pull
the free end (3) from the buckle.
An optional 3 inch wide seat belt is available for those locations that require
a 3 inch seat belt.
WARNING:
Death or serious personal injury may result
from failure to wear the seat belt installed on this vehicle. The seat
belt is a critical component of the Operator’s protective Structure,
and is provided for the operator’s protection in case of vehicle
upset. The seat belt MUST be worn whenever this vehicle is oper-
ated.
OL0430
1
OPTIONAL 3 INCH WIDE
SEAT BELT
STANDARD 2 INCH WIDE
SEAT BELT
2 3
3