Mueller Corrugated Panel - Manual (Page 15)

15 15
HIGH SIDE RESIDENTIAL EAVE TRIM INSTALLATION
Details are subject to change without prior notice.
1. Attach the high side trim (#0802) to the fascia with woodgrip screws on 5’ centers. Make sure the 6” side
of the trim is on the rooftop with the hem resting on the highs.
2. Cap the ends of the trim by cutting and folding a tab that attaches to the gable trim. Capping is usually easier
to do before the trim is installed. If done after the trim is installed, be sure and leave 6” of the trim overhanging
to allow enough material for cut and folds.
3. Position the corrugated closure on the sheet.
4. Attach with one lap screw, 12” O.C. on the high of the corrugation, through the hem of the high side eave
trim and corrugated closure. Care must be taken not to over-tighten the screws, as this will distort the trim
and closures.The screw hole can be pre-drilled, if desired.
5. All end laps should be at least 4”. Secure it to the overlapped piece with caulk and stitch screws.
NOTE: Alternate trim profiles are acceptable using the screw pattern shown.