J.P. Instruments EDM 930 Primary Pilots Guide - Manual (Page 19)

For Your Safe Flight Page 14
RPM and MAP Displays
The upper left side of the display
shows RPM above the MAP. The arcs
represent the analog values. Percent
horsepower is shown to the lower left
of MAP.
Scanner Displays
Scanner EGT and CHT Analog Bar Graph
The height of each column represents a EGT or CHT or TIT (if
installed) temperature. The graph resolution depends on the programmed
span between the top and bottom of the range marks. Note: when in
certain modes, such as leaning or normalize, the EGT resolution will
temporarily be finer.
Cylinder Numbers and Index
Just below the bar graph columns are numbers identifying the respective
cylinder. If TIT is installed, it is labeled by the letter T underneath. A
square ‘Cylinder I.D. Index’ surrounding a number indicates what
cylinder is currently selected and relates to the digital display.
Scanner Digital Display
Located under the Scanner bar graph area is the alphanumeric display. It
displays alphanumeric values for different parameters as well as status
and alarm messages.
63 % HP