J.P. Instruments EDM 960 Twin Primary Installation Manual - Manual (Page 31)

FAA Approved Installation Manual for the EDM-960 system Report No 909
Primary Engine Data Management System Page 31 of 46 Rev D
Date 2-6-2014
1 Stainless Steel Exhaust Seal Washer
Component Parts list for CARB (KIT 1190) probe
1 P/N 400128, CARB probe
2 Ring Terminals
2 Screws and Nuts 6-32 X1/4"
1 Fiberglass tube 3/8” x 5”
35.5 Component Parts list for OIL Temperature probe (KIT 1250 )
1 P/N 400509 OIL probe
1 AN900-10 crush washer
2 Ring Terminals
2 Screws and Nuts 6-32 X 1/4"
1 Fiberglass tube 3/8” x 5”
35.6 Component Parts list for Oil Pressure sensor KIT 1240
1 P/N 159936A Oil Pressure sensor
1 P/N 159961 Clamp, Loop Cushioned
1 P/N 174402 Connector Pack 3 Pin and Terminals
35.7 Component Parts list for Fuel Pressure Sensor KIT 1450 (only if required by POH)
1 P/N 159935A Fuel pressure sensor
1 P/N 159961 Clamp, Loop Cushioned
1 P/N 174402 Connector Pack 3 Pin and Terminals
35.8 Component Parts list for Kit 1480 Differential Fuel Pressure (only if required by POH)
1 P/N 159938 Fuel pressure sensor
1 P/N 159961 Clamp, Loop Cushioned
1 P/N 174204 Connector MS 3116F8-4S
35.9 Component Parts list for Kit 1300 ampere shunt
1 P/N 159920 100 amp shunt
2 Ring Terminals
35.10 Component Parts list for Fuel Flow Transducer
1 fuel flow transducer, 201 or 231 PN 700900-1,-2
8 inches of 1.5” dia. fire sleeve
1 3-pin connector housing
3 female pins
2 AN816-4-4 fittings (Continental) or AN816-4-6 (Lycoming)
35.11 Component Parts MAP sensor KIT 1440
1 P/N 159934A Manifold pressure sensor
1 P/N 159961 Clamp, Loop Cushioned
1 P/N 174402 Connector Pack 3 Pin and Terminals
35.12 Components Parts list for pressurized RPM sensor
Slick 6000………………………….….P/N 420809
Bendix magneto 20, slick 600………P/N 420806
Bendix Dual ………………………….P/N 420808