PHCC Pro Series Pro Series C22 - Manual (Page 3)

Introduction
The Pro Series Pair of Pumps combination system
is designed to provide both primary and backup
pumping capabilities. The primary pump will
operate as long as it is receiving AC power. If
the power is interrupted, or more water is
coming into the sump than the AC pump can
handle, the backup sump pump will begin
pumping automatically. The backup system has
unique monitoring features that diagnose a
problem and sound an alarm. A light on the
display panel of the control unit will indicate the
cause of the alarm and the corrective action.
The two systems have been pre-assembled for
easy installation.
For added reliability, the float switches have, not
one, but two floats. Should one float fail to
operate, the second float will automatically
activate the pump.
The Pair of Pumps Combination Sump Pump
System includes:
• A 1/3 HP primary pump with a caged dual
float switch, and a blue piggyback controller
that plugs into the wall outlet
• A blue backup pump
• A gray control unit with a battery fluid
sensor, a dual float switch, battery cables,
and a 20-amp fuse
• A battery charger
• A battery cap with a hole to accommodate
the fluid sensor
• A battery box
• A rubber union
• A battery filler bottle for adding distilled
water to the battery
You will also need to supply:
• A Pro Series 2200 Standby Battery*
• DO NOT use an automotive battery with this
system
• DO NOT use a Pro Series 1000 battery with
this system. It will not run the pump as long
as the Pro Series 2200 battery
• A surge protector (recommended - backup
controller only)
• Six (6) quarts of 1.265 specific gravity
battery acid
* PHCC Pro Series standby batteries are
specifically designed to work with your
battery backup sump pump system.
Glentronics can not guarantee the
compatibility of other brands of batteries.
For optimal performance the use of a
PHCC Pro Series standby battery is
recommended.
For some installations you may need
additional items:
• 1-1/2” rigid PVC pipe to connect to the
existing plumbing
• A PVC pipe connector or a rubber union
• PVC pipe cleaner and cement
System Specifications
Power supply requirements.......115 volts, 60 Hz
AC pump pumping capacity..... 2770 GPH @ 10’
............................................. 46 GPM @ 10’
DC pump pumping capacity..... 1730 GPH @ 10’
............................................. 29 GPM @ 10’
Overall dimensions................. 11” W x 23¾” H
Page 2
Rubber
Union
Primary Pump Controller
Backup
Pump
Controller
Primary
Pump
Cable Tie
Battery Cap
Backup Pump
Float Switch
Backup
Pump
Battery Box
Battery
Filler
Bottle
Primary
Pump Float
Switch
Battery
Wires
Fluid Sensor