AEM 30-1931 Universal Fuel Ignition Controller 8 Channel - Manual (Page 23)

Page 23
MAF:
Select the load input and operating mode for the MAF map. Set the
maximum voltage clamp (max output voltage) for the MAF map.
Analog A(B):
Select the load input and operating mode for the Analog A(B) map.
Analog C:
Set the “Units name” for the Analog C input. Turn the 2.2Kohm pull-up
resistor on and off. Open the Analog C voltage table
O2:
Select the load input and operating mode for the O2 map. Set the period
for the fixed and percentage modes. Set the high and low voltages for bank 1
and bank 2. Set the Start Delay time, which is the amount of time in seconds
that the F/IC waits for the O2 outputs to be functional after the F/IC is turned on.
Select the High Level Drive option (This option allows for better AFR resolution
on certain vehicles with UEGO style oxygen sensors). Select the view as AFR
option.
FIC Logger:
Set the on conditions and sample rate for the FIC internal logger. Note:
The on conditions must be met and the logger trigger input must be grounded
before the internal logger will begin logging.
Switched 12Vdc:
Set the on/off conditions for the Switched 12Vdc output wire.
Frequency:
Select the load input, operating mode, frequency range, clamp high, and
clamp low frequencies for the frequency channel.
Boost:
Select the load input and start pressure for the boost control functions.
Enable and disable “Over-boost protection”. Set the over boost conditions