AEM 30-4110 Digital Wideband UEGO Gauge User Manual
Page 9
Advertising
Page 9
Verify the settings above and click OK. When power is supplied to the AEM UEGO Gauge, AFR
(or Lambda) data will be displayed, as shown below. (Figure 6)
Figure 6. Data logging with HyperTerminal
UEGO Sensor
The 30-4110 is compatible with Bosch LSU4.9 sensors *only*. This sensor can be
identified by the connector as shown in Figure 7.
Figure 7. Use only Bosch LSU4.9 Sensors!
If attempting to route the UEGO Sensor through a tight space, AEM recommends
routing the smaller six pin connector through the hole. If the UEGO sensor is to be put
through a conduit or firewall, a 1.05in (26.7mm) drill is required.
Advertising