AEM 30-5140M Analog Oil Transmission Water Temperature Metric Gauge - Manual (Page 3)

Page 3
Changing the Bezel and Faceplate
The gauge kit comes with the black bezel and black faceplate installed. However, the
kit also comes with a silver bezel and multiple faceplates. Instructions on how to
change the faceplate are included in the kit on a separate sheet of paper. To change
the bezel, orient the gauge so you are looking at the faceplate. Rotate the bezel
counter-clockwise to unscrew it from the gauge cup. The bezel, lens, and rubber
spacer are all removable. Reassemble the gauge as shown below in Figure 3. Note:
When reassembling the gauge, it may be necessary to apply a light amount of pressure
on the lens and spacer to keep the faceplate from rotating when reinstalling the bezel.
Do not over tighten the bezel when reassembling the gauge.
Backlighting
The AEM Boost Gauge has 7 different backlight colors available to the end user, which
closely match some of the more common factory dash panels: white, blue, green, red,
orange, light blue, and aqua. To change the backlight color, rotate the backlighting
switch using a small precision style screwdriver. The backlight switch is accessed
through the small hole in the back of the gauge.
Figure 3. Changing Bezels
BEZEL
LENS
RUBBER
SPACER