AEM Infinity Supported Applications - Toyota 1993-1997 Supra Turbo - Manual (Page 6)

6
© 2014 AEM Performance Electronics
IMPORTANT IDLE AIR CONTROL VALVE REQUIREMENTS
Many Toyota, Mitsubishi, and other vehicles use an Idle Air Control Valve with a Unipolar Stepper Motor
(6-pin connector) and MUST be modified. See instructions below. A Bipolar Stepper Motor (e.g., GM)
will have a 4-pin connector and DOES NOT need to be modified.
*This info does not apply to vehicles that utilize IACV solenoids.
The 2 center pins (Black-Red wires) supply 12V power to the stepper motor in the factory setup,
however these pins MUST BE DISCONNECTED before powering the AEM Infinity ECU.