JB Conversions 16-1205 HD Standard Length SYE Kit Using OEM Housing - Manual (Page 10)

10
FIG: 15
17) Inspect the inside of the main drive sprocket for the presence of
needle bearings. If the bearings are present, remove them with a
press. The deletion of these bearings is per OEM design. After 1995,
the mfg. (New Venture Gear) adopted this design and it performs fine
(Fig.16,17).
FIG: 16 FIG: 17
18) Install the main sprocket assembly onto the new output shaft.
Retain this assembly with the new retaining ring supplied in the kit
(Fig.19).