JB Conversions 16-1205 HD Standard Length SYE Kit Using OEM Housing - Manual (Page 15)

15
28) Install the oil seal into the aluminum bearing retainer (both
supplied in the kit) (Fig.34).
FIG: 34
29) Apply a liberal amount of grease to the oil seal (Fig.35).
FIG: 35
30) Install the new bearing supplied in the kit into your existing
aluminum tail-housing (Fig.36). Note that the new bearing has a
raised inner race on one side. This raised race points to the
inside of the tail-housing. Apply a bead of RTV sealant to the
bearing housing and 4 socket head cap screws. Secure the aluminum