JB Conversions 2308 Dana 300 - Manual (Page 11)

11
15) Be sure to push the bearing all the way onto the top of the bearing
during shim setup (Fig.16).
FIG: 16
16) End play must be checked for proper bearing preload. Push the bearing
number 30207 onto the shaft as shown (Fig.17). You will need to install the
yoke and "special setup nut" (torque to 180 ft-lbs) before checking
endplay. Use a dial indicator (not shown) to observe 0.000"-0.0015" of end
play. It is easier to perform the endplay adjustments at this time instead of
later in the installation after the remainder of the entire case is being
handled.