JB Conversions 2308 Dana 300 - Manual (Page 19)

19
31) Roll the idler gear into place rotating it as it is lowered (Fig.37).
FIG: 37
32) When the idler gear is located properly, the intermediate shaft can be
easily pushed through the center of the idler gear. Pay close attention and be
sure all of the needle bearings remain in place during this procedure. Align
the intermediate shaft with the flat side in the position shown. This will allow
the retainer plate and bolt to be installed after the intermediate shaft is
tapped into the final position (Fig.38,39). Install the shift rail caps if they
have been removed.
FIG: 38 FIG: 39