JB Conversions 2308 Dana 300 - Manual (Page 4)

4
3) Remove the rear output yoke nut and end yoke. Remove the 5 bolts
holding the rear bearing housing to the case (Fig.4). New bolts are supplied
in the kit.
FIG: 4
4) Using a bearing puller, remove the aluminum housing from the case
(Fig.5). The rear outer tapered roller bearing will slide off of the shaft as the
housing is removed. You do not have to remove the oil seal to perform this
step. If you have the type of puller that is designed to remove tapered roller
bearings, remove the last tapered roller bearing from the output shaft.
FIG: 5