Boundless Technologies 4000 - Manual (Page 30)

STEP 5 – Communications Setup Selections 15
STEP 5 – Communications Setup Selections
To complete this step, you must recall the letters next to the connections that you
made in Step 2.
The procedures below correspond directly to the individual connections made.
Notice that only certain connection procedures are to be followed, not all of them.
For example, if you have made connections “C” and “F” to a modem and a serial
printer, then follow connection procedures “C” and “F” below.
Only follow those steps that apply to your connections (A-G).
To access the Setup menu, press SHIFT-SETUP on an ASCII keyboard or Shift-Print
Scrn on a PC+ keyboard.
Connection A: Host DCE
1. Enter the Setup menu.
2. In the COMM menu, set the proper communications settings for the EIA Baud,
EIA Data Format, EIA Parity Check, EIA Recv, and EIA Xmt selections. See
the Setup chapter for more information on the individual settings.
Connection B: Host DTE
1. Enter the Setup menu.
2. In the AUX/COMM2 menu, select the proper communication settings. See the
Setup chapter for more information on the individual settings.