Compass, Clock, Compass -4 clock -4 – Buick 2011 Regal User Manual

Page 106: Ultrasonic

Advertising
background image

5-4

Instruments and Controls

windshield washer had been
activated. See Washer Fluid on
page 10‑22
for information on filling
the windshield washer fluid
reservoir.

{

WARNING

In freezing weather, do not use
your washer until the windshield
is warmed. Otherwise the washer
fluid can form ice on the
windshield, blocking your vision.

Compass

The vehicle may have a compass
display on the Driver Information
Center (DIC). The compass receives
its heading and other information
from the Global Positioning
System (GPS) antenna, StabiliTrak,
and vehicle speed information.

Avoid covering the GPS antenna for
long periods of time with objects
that may interfere with the antenna's
ability to receive a satellite signal.
See Backglass Antenna on

page 7‑13 and Satellite Radio
Antenna on page 7‑14
for the
location of the vehicle's antennas.
The compass system is designed to
operate for a certain number of
miles or degrees of turn before
needing a signal from the GPS
satellites. When the compass
display shows CAL, drive the
vehicle for a short distance in an
open area where it can receive a
GPS signal. The compass system
will automatically determine when
the GPS signal is restored and
provide a heading again. See
Compass Messages on page 5‑25
for more information on the
messages that may be displayed for
the compass.

Clock

The infotainment system controls
are used to access the time and
date settings through the menu
system. See Operation on
page 7‑4
for information about
how to use the menu system.

Setting the Time and Date

1. Press the CONFIG button and

select Time and Date Settings.

2. Select Set Time or Set Date.

3. Turn the

Z

knob to adjust

the highlighted value.

4. Press the

Z

knob to select

the next value.

5. To save the time and return to

the Time Settings menu, press
the

0

BACK button at any time

or press the

Z

knob after

adjusting the minutes.

Setting the 12/24 Hour Format

1. Press the CONFIG button and

select Time and Date Settings.

2. Highlight 12/24 HR Format.

3. Press the

Z

knob to select

the 12 hour or 24 hour display
format.

Advertising