MBW CG200 - Manual (Page 23)

21
INSTALLING VIBRATORS:
1. The vibrator in the main unit is
installed at the factory.
2. The 12" hopper requires use of one
additional vibrator. The 24" and 36"
hopper require the use of two addiĆ
tional vibrators.
3. The vibrator hydraulic ports are loĆ
cated directly below the steering
yoke at the front of the main unit.
Hoses and ports are equipped with
quick disconnect fittings. Ports are
arranged in pairs top and bottom.
Replace the rubber quick disconĆ
nect covers when the ports are not
in use.
1 2
3
NOTE: Any vibrator parts which are not being used, the corresponding vibrator control must
be switched off completely or you will dead head (a restricted flow of hydraulic fluid that
will kill the engine) the hydraulic system
CHANGING HOPPERS IN
THE SIDE UNIT:
1. Disconnect the side unit from the
main unit. Brace the side unit to
prevent it from tipping.
2. Remove the bolts holding the hopĆ
per flange to the side unit frame. Lift
the hopper out of the side unit.
3. Place the new hopper in the side
unit and install the bolts.
BRACE