MBW CG200 - Manual (Page 43)

41
CHECKING ENGINE FAN BELT:
STOP ENGINE BEFORE CHECKING.
1. Apply moderate thumb pressure to
fan belt halfway between pulleys. The
belt should deflect approximately
3/8" to 1/2" (10 mm to 13 mm).
2. Loosen adjusting nut on alternator to
adjust belt. Move alternator as reĆ
quired. Tighten nut. Check belt tenĆ
sion.
3. Replace belt if it is damaged or
cracked.
CHECKING HYDRAULIC OIL LEVEL:
1. Park paver on a flat surface.
2. Remove cover from hydraulic oil
tank. Oil level should be between
2-1/2" & 3.0" ( 64 mm & 76 mm)
from the bottom of the dipstick. Add
oil as required.