Lukas PO6 User Manual
Page 3
3
3
General safety instructions
3.1
In the event of malfunctions, stop the machine immediately and lock it. Have any defects
rectified immediately.
3.2
Before starting up or setting the machine in motion and during operation of the machine make
sure that nobody is at risk.
3.3
Before transporting the machine always check that the accessories have been safely stowed
away.
3.4
Make sure that there is enough lighting during work.
3.5
Avoid any operation that might be a risk to machine stability.
3.6
Check the machine at least after every operation for obvious damage and defects. Report any
changes (incl. changes in the machine’s working behaviour) to the competent organization/person
immediately. If necessary, stop the machine immediately and lock it. All lines, hoses and screwed
connections have to be checked for leaks and obvious damage. Repair damage immediately.
Splashed oil may cause injury and fire.
3.7
All safety equipment has to be checked for completeness and flawless condition:
-
instruction markings and warning signs (safety instructions)
-
check safety cover (e.g. motor-safety covers, heat protection etc.) if they are available and
if they are in good condition.
3.8
Working under loads is not allowed if they are only lifted by hydraulic cylinders. If the work is
indispensable sufficient mechanical supports are needed additionally.
3.9
Make sure that hoses are not mechanically stressed (pulling, bending etc.).
3.10
When working in the vicinity of live components and cables, suitable precautions must be
taken to avoid current conductions or high-voltage flashovers to the motor pump.
3.11
During use of the power package, the creation of electrostatic charges which could result in
sparking must be prevented.
3.12
The power package should always be placed in such a way that its function and safety will
not be impaired by strong external temperature influences.
4
Instructions for maintenance and service
4.1
For the execution of maintenance and service work, tools and workshop equipment adapted
to the task on hand are absolutely indispensable.
Work on the hydraulic system must be carried out only by personnel having special knowledge and
experience with hydraulic equipment.
4.2
Before putting into operation clean the machine, especially connections and threaded unions,
of any traces of oil, fuel or preservatives before carrying out maintenance/repair. Never use
aggressive detergents. Use lint-free cleaning rags and pay attention that the components are
meticulously clean during reassembling after repair.
4.3
During dismantling of machines it is necessary to collect the outrunning hydraulic liquids
completely, so that they cannot reach the ground. They have to be disposed properly according to
the instructions.