Lukas PO6 - Manual (Page 8)

8
11.2 Carry frame
To facilitate their transport, the power packs can be upgraded with a carry frame which must be
ordered separately as a mounting kit.
Ref. no. for power packs with 10l - tank V84150/7601-03.
Ref. no. for power packs with 25l - tank - upon request.
11.3 Quick-connect couplings
All power packs can be equipped with quick-connect couplings. Your LUKAS leader will be glad to
offer you the couplings that you need.
12 Maintenance
12.1 Oil level/Oil change
- Check the hydraulic oil level after each operation and fill in new oil, if necessary.
- Check the hydraulic power pack for possible leakages.
- The cylinder must be retracted for filling in oil.
The desired oil level can be checked with the dipstick. (see 6.1.4 resp. 6.1.5)
The oil change should be made after approx. 100 operating hours. The cork gasket and the sealing
ring on the oil drain plug must be replaced with each oil change. The intervals between further oil
changes depend on the operating hours and the pollution of the oil.
12.2 Oil for LUKAS hydraulic tools mineral oil DIN 51524 and others
recommended range of viscosity : 10...200 (mm 2 /s).
12.3 Preventive Maintenance
The oil tank must principally be cleaned with each oil change. To clean the oil tank, the mounting
nuts on the oil tank cover must be loosened and the motor/pump unit pulled out.
Attention: Do not use textiles!
The tank must be cleaned by flushing with hydraulic oil.
13 Service
Service may be carried out exclusively by the manufacturer of the device or by personnel trained
by the manufacturer and the authorized dealer.
Only genuine LUKAS spare parts may be used for repair works.
When carrying out maintenance or service works be sure to wear protective clothing (see safety
regulations), since hydraulic devices may be under pressure even in unoperated state.
Oil temperature range Viscosity rating Comments
A - 24 ... + 30 °C HL 5
B - 18 ... + 50 °C HLP 10
C - 8 ... + 75 °C HLP 22
D + 5 ... + 80 °C HLP 32
E - 8 ... + 70 °C HF - E 15 Biodegradable