Synergy 5051 - Front 3 Link Kit for Jeep TJ User Manual
Page 6
Advertising
SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
14. Decide which side you want the upper control arm on. It usually goes on the side that
the drive shaft is on. Driver side for a TJ or YJ. Weld the upper control arm top plate
and gusset as shown below. There of two of these brackets included, you can use
both and make a triangulated 4-link. The opposite side frame bracket without the
upper control arm gets the 2 vertical gussets.
Advertising