Synergy 5221 - 07-10 Jeep JK 2/4 Door Front Cage Kit - Manual (Page 7)

14. The images below are taken as a reference for cutting the underside of the body in
order to fit cage tie-ins. Trace a rectangle that goes 6” back from the middle of the
stock rocker threaded hole to the middle of the 1” x 2” rectangle. Continue the
rectangle 1” forward from the threaded hole to just about where the bottom of the
body contours up. See image 14.1 and 14.2 below.
Image 14.1
Image 14.2
15. Next, cut off the inner edge closest to the frame rail. Be careful not to cut the floor or
frame when cutting.