Synergy PPM-8055 - Manual (Page 5)

9. If you are not using the anti-sway bar relocation brackets and want to mount the sway
bar links in the factory location, install the passenger side anti sway bar link between
the track bar bracket and factory sway bar tab as shown below. Attach the driver side
anti-sway bar link in the factory location.
10. The track bar relocation bracket also allows you to relocate the steering stabilizer to
the top of the tie rod. Remove the steering stabilizer from the axle bracket and from
the tie rod bracket.
11. Loosen the u-bolts on the tie rod steering stabilizer bracket and rotate it to the top of
the tie rod as shown below. Tighten the u-bolts when finished.
 NOTE – This can only be done on 2007-2010 models. 2011+
models require the use of PPM-8003 Synergy Jeep JK Fox
Steering Stabilizer Tie Rod Clamp.