Bassworx BA150.2 - Manual (Page 14)

FRONT PANEL
4 CHANNEL
13
Adjustments
1. Set to the "H.P.F" position when the amplifier is used to drive a tweeter/midrange system. The
frequencies below the crossover point will be attenuated at 12dB/octave. Permits adjustment
of the crossover frequency ,by rotating the knob to select any frequency between 60Hz to 1.2KHz
as the crossover point.
2. Set to the "L.P.F" position when the amplifier is used to drive a subwoofer. The frequencies above
the crossover point will be attenuated at 12dB /octave. Permits adjustment of the crossover
frequency, by rotating the knob to select any frequency between 50Hz to 250 Hz as the crossover
point.
3. Set to the "OFF" position when the amplifier will be used for driving full-range speakers. The full
frequency bandwidth will be output to the speakers without high or low frequency attenuation.
4. Level adjustment-The sensitivity adjustment is to allow the amplifier to work with many different
brands of head units. It allows input signal to vary between 350 millivolts to 5 volt from the head
unit or other signal processor. Start by setting the sensitivity adjustment to the "MIN" (3 volts).
Using a cassette or compact disc that you are familiar with ,turn on head unit to the 3/4 volume
setting. Slowly turn up sensitivity adjustment towards the "MAX" (200 millivolts) using a flat head
screw driver. Stop turning on the onset of distortion and turn back just a slight. The 3/4 volume
setting is now the "maximum" volume for the head unit. The goal is to keep the level control to the
lowest setting yet still have enough signal to drive the amplifier. This is done to prevent over driving
the amplifier and to keep system noise to a minimum. It is important not over drive speakers (at
point of distortion) this will cause permanent damage to the speakers. Also,
if the amplifier itself is over driven, it could be damaged.
LOW INPUT LOW INPUT POWER POWER PROTECT PROTECT LINE OUTPUT LINE OUTPUT REMOCON REMOCON
LEVEL LEVEL
6V 6V 15Hz 15Hz 50Hz 50Hz 60Hz 60Hz ON ON L.P.F L.P.F
L.P.F L.P.F
FULL FULL 0.24V 0.24V 45Hz 45Hz 250Hz 250Hz 1.2kHz 1.2kHz OFF OFF H.P.F H.P.F
H.P.F H.P.F
0dB 0dB 12dB 12dB
BASS
EQ BASS
EQ LOW
PASS
LOW
PASS
HIGH
PASS
HIGH
PASS
SUBSONIC FILTER SUBSONIC FILTER
LL LL
R R R R
PHASE
PHASE
00 180 180
SLAVE LINE INPUT
ON OFF
L.P.F
50Hz
GAIN
6V 0.24V 15Hz 250Hz
SUBSONIC
50Hz
FILTER REMOCON
PHASE
180°
MASTER SLAVER
R
L
0°
MONO CHANNEL
2 CHANNEL
LOW INPUT POWER PROTECT
LINE
OUTPUT
REMOCON LEVEL
6V 15Hz 50Hz 0.24V 45Hz 250Hz 0dB 12dB
BASS
EQ LOW
PASS
SUBSONIC FILTER
L L
R R PHASE
0 180 ON OFF
1 CHANNEL