Bassworx BA150.2 - Manual (Page 2)

1
Congratulations on your Purchase
Your new high fidelity bridgeable/stereo amplifier is designed to deliver maximum enjoyment and one
year of trouble free service. Please take a few moments to read this manual thoroughly.
It will explain the features and operation of your unit and help insure trouble free installation.
Features
CLASS ''D''
¡
Fully 1 Ohm Stable Operation
¡
Military Spec Audiophile Grade Components
¡
High Efficiency PWM Power Supply
- Multi-stranded Power Torroid
- Two Torroidial Core
- MOSFET Transistors
¡
Over Sized Capacitor Banks
¡
Discrete Mount Power & Speaker Terminals
¡
Varible Lowpass Electronic Crossover
¡
Varible Subsonic Filter
¡
3way Protection Circuitry
¡
Soft Remote On/off Circuitry
¡
Digital Subwoofer Level Control
CLASS ''AB''
¡
Class ''AB'' Technology MOSFET PWM
Power Supply.
¡
Bridgeable & TRI-Mode Operation.
¡
Continuously Variable 12dB/Octave
High Pass & 12dB/Octave Low Pass
Crossover.
¡
Subwoofer Variable Crossover for Deep
Bass Control.
¡
Enhanced Variable Bass Boost
+12dB @ 50Hz.
¡
Soft Start & Muting.
¡
Overload, Thermal, Short Circuit Protection.
¡
Power & Protection indicator.
Precautions: Read First!
-
If after reading the direction you feel uncomfortable about installing the amplifier in your car, or not
equipped or competent to do so, you should have the amplifier installed by an authorized installer.
It's your car!
-
Negative battery terminal must be disconnected before any electrical connection are made.
-
Be sure choose a location that provides substantial ventilation for the amplifier. The most preferred
locations would be in your car's trunk, under the front seats or on the back wall of a truck.
-
The location chosen should provide at least 2" of clearance above the amplifier for adequate
ventilation.
-
If the amplifier is to be mounted vertically be sure that it is in a place where adequate air will flow
along the length of its heatsink fins for cooling.
-
NEVER mount the amplifier up side down, this will cause the heat to rise back into the amplifier
causing thermal shutdown or possible permanent damage.
-
NEVER mount the amplifier in a location that is subject to direct sunlight or exposed to moisture.