Bassworx BA150.2 - Manual (Page 4)

3
Installation
MOUNTING:
1. After reading precaution, decide where you are going to install the unit. Also, see Fig.1.
2. Once the location has been determined, place the amplifier in position. Using a felt tip pen or pencil
mark the four holes to be drilled for mounting. NEVER use the amplifier as a template for drilling.
It is very easy to damage the amplifier surface in manner.
3. Remove amplifier. Drill four 3.5 m/m. Diameter holes into mounting surface on steel panel.
If you want mounting the MDF or wood panel, drill four 3.0m/m diameter holes into mounting surface.
4. If possible, test the system operating before final mounting of the amplifier.
5. Mount the amplifier using the supplied 4 self threading screws.
Installation Diagram
SELF TAP SCREWS
Fig1.