BenQ ESG-103 - Manual (Page 10)

Chapter 2 Hardware Installation - 6
2.5 Power on
(1) Connect your power adapter to DC inlet to power on your ESG-103
(2) Turn on ADSL / Cable modem's power
(3) Finish
2.6 LED Indication
LED State Indication
Power On (Green)
A steady power LED shows that the
power is applied.
Status On (Orange)
When power is on, ESG-103 will do some
initialization jobs. Then this LED will blink
steadily.
WAN
Link (Green)
When connect to the ADSL / Cable
modem, the LED should be green. If this
LED is not being lighted, this means link
fails.
TX / RX (Green)
When data is transmitted or received, this
LED will be blinking.
LAN
1X,2X,
3X,4X
Link (Green)
When ESG103 is connected to your PC,
the LAN LED should be on.
TX / RX (Green)
When data is transmitted or received, this
LED will be blinking.