Bel Canto Design PRe3 - Manual (Page 6)

page 7 © 2006 bel canto design, Ltd. PRe3 User’s Guide 0206 Rev. A
Mute: (available only on the
remote)
The PRe3 starts up in Soft Mute. This
level is 20dB below the displayed vol-
ume level. When MUTE is first pressed it
goes to the Soft state, indicated by 2
decimal points on the volume display
(i.e. 50.0.). Pressing MUTE again rapid-
ly will fully MUTE the outputs. Full mute
is indicated by 4 decimal points in the
volume display (i.e. .5.0.0.).
Pre In:
This is used to toggle through the inputs,
when initially pressed it will indicate the
currently selected input.
Standby:
Used to toggle the PRe3 into and out of
standby mode. Standby hard mutes the
outputs while keeping all circuitry run-
ning, maintaining optimum circuit per-
formance. Before unplugging the PRe3
from mains power it is recommended to
place it in standby first. Standby is indi-
cated by the presence of 2 dashes on
the display - - .