IKA EUROSTAR 100 control - Manual (Page 6)

6
Unpacking
• Unpacking
- Please unpack the device carefully
- In the case of any damage a detailed report must be sent im-
mediately (post, rail or forwarder).
• Delivery scope
- EUROSTAR 60 control or EUROSTAR 100 control stirrer
with a Wireless Controller (WiCo) of the type ordered
- An operating instructions
- An extension arm
- A hexagonal socket screw
- A hexagon socket offset screw key
- A chuck key
- A protective cover
- A warranty card
- OS 1.0 power supply unit
- USB cable micro A – micro B 2.0
- USB cable A – micro B 2.0.
Correct use
• Use
For mixing/stirring liquids with low to high viscosities by various
stirring tools.
Intended use: Stand device (chuck points down).
• Range of use (indoor use only)
- Laboratories - Schools
- Pharmacies - Universities
• Wireless remote control
Before using the wireless link between the Wireless Controller
(WiCo) and the laboratory device, first check whether your re-
gion is included in the radio communications approval for the
device. If it is not, remote control can also be performed using
a USB cable.
This instrument is suitable for use in all areas except:
- Residential areas
- Areas that are connected directly to a low-voltage supply net-
work that also supplies residential areas.
The safety of the user cannot be guaranteed:
- If the instrument is operated with accessories that are not sup-
plied or recommended by the manufacturer
- If the instrument is operated improperly or contrary to the manu-
facture’s specifications
- if the instrument or the printed circuit board are modified by
third parties.
Drive
The rotary knob (B, see Fig. 1) of the Wireless Controller (WiCo) allows the speed of the stirrer to be adjusted over the entire speed range.
OS 1.0 power supply unit (for Wireless Controller (WiCo))
Adapter
England
Adapter
USA, China
Adapter
Australia
Adapter
Europe, Switzerland
Motor protection
The stirring instrument is suitable for continuous operation. The
motor current is limited electronically. The instrument has an anti-
stall and anti-overload system. If a fault occurs, a safety circuit immediately switches off the mo-
tor permanently through a relay in the power board. A fault occurs
if the safe functioning of the instrument is compromised.
Speed – normal operation
Speed - regulated (no variation in speed)
The speed is monitored and regulated by processor controlled.
The target speed is constantly compared with the actual rota-
tion speed value of the output shaft and variations corrected. This
guarantees a constant speed even if the viscosity of the substance
being stirred changes.
Fluctuations in mains voltage within the permitted tolerance range
have no effect on the quality of regulation and constancy of speed.
The speed is set using the front knob (B, see Fig. 1). During normal
operations the speed value on the display (C, see Fig. 1) corresponds
to the speed of the output shaft in revolutions per minute (rpm).