Eppendorf New Brunswick -86 °C Freezers Innova U360 - Manual (Page 13)

13
Innova® U360 -86 °C Freezers — Operating manual
4 Installation
4 Installation
4.1 Preparing installation
4.1.1 Setup guide
The following is a quick-start guide to setting up the freezer. More detailed information is
presented in subsequent sections to clarify the process.
1. Unpack the freezer and remove it from its packing pallet.
2. Place the freezer in its designated location.
3. Remove the contents from the inside of the freezer.
4. Unwrap and install the shelves (if provided).
5. Install the mains/power cord and lock it in place.
6. Install the keys in the door lock and the mains/power switch cover lock.
7. Plug the freezer into the mains/power supply and turn the freezer on.
8. Set the time, date and set temperatures (see Operating temperature and alarm setpoints on
p. 20).
9. Wait until the freezer has reached its setpoint temperature before placing anything inside the
freezer.
4.2 Selecting the location
All U360 freezers are mounted on castors for ease of movement. Upright freezers have feet that
provide both a leveling feature and a locking feature to stop the freezer from rolling once it is in
place.
Position the freezer to allow disconnection to be made in respect to removal of the plug or
appliance coupler, also the free air entry through the intake grille in the front and free air exit from
the back. Provide a clearance of at least 150 mm (6 in) on all sides.
For efficient temperature control, the freezer should be placed in a shaded area, away from
sources of excessive heat. For maximum cooling capability, the product should be located in an
air-conditioned room.
4.3 Installing the shelves
Models U360 is supplied with two adjustable shelves. These can be positioned in 12.7 mm (½-in)
steps anywhere throughout the freezer. To effectively utilize racks within the freezer, be sure to
position them so that each shelf is aligned with the bottom of each inner door.
Perform the following steps to install the shelves:
1. Ensure that the freezer is turned off and unplugged.
2. Remove the protective plastic coating from the shelf.
3. Position the four shelf clips evenly within the freezer by squeezing the clip, then inserting it
into the shelf support within the freezer.
WARNING!
Risk of personal injury
 DO NOT attempt to lift any freezer by hand. Preferred lifting for loading and unloading is by
mechanical lifting equipment.
NOTICE!
Risk of material damage
 Maintenance, adjustment and repair work should be carried out only by QUALIFIED,
EXPERIENCED personnel who have been AUTHORIZED to undertake such work by New
Brunswick Scientific or its authorized agents.
 Failure to use authorized service agents will invalidate the warranty.
4
Installation