Eppendorf Innova 40R Shaker - Manual (Page 19)

Installation
New Brunswick Innova 40/40R Shaker
English (EN)
19
5. Reinstall and secure the 4 screws.
4.3 Install flask clamp
Materials needed:
• Phillips screwdriver
• 10 – 24 × 5/16 in (7.9 mm) flat Phillips screws
Flask clamps purchased for use with universal platforms require installation (see Accessories on p. 53).
Clamps are installed by securing the base of the clamp to the platform with the correct type and number of
screws. All clamps are shipped complete with hardware.
Clamps for 2 L and 2.8 L flasks are shipped with an additional girdle to keep the flasks in place. The girdle
is an assembly of springs and sections of rubber tubing. One girdle is already in place on the clamp, the
other is packed separately.
Abb. 4-2: Double girdle clamp
Fig. 4-2: Double girdle clamp
New Brunswick flask clamps are used on a variety of shaker platforms. Flat head screws of
different lengths and thread pitch are used to secure the clamp.
1 Clamp mounting holes (with screws)
2 Upper girdle with girdle tubes
Secures the flask within the clamp.
3 Lower girdle with girdle tubes
Prevents the flask from spinning
4 Clamp body (legs and base)
1 2
4 3