Eppendorf Innova 40R Shaker - Manual (Page 20)

Installation
New Brunswick Innova 40/40R Shaker
English (EN)
20
To install these double girdle clamps:
1. Place clamp on platform, aligning it mounting holes with the holes on the platform.
2. Secure the clamp in place using Phillips screwdriver and screws provided.
3. With the first girdle in place, as delivered, on the upper part of the clamp body, insert an empty flask
into the clamp.
4. After making sure the sections of tubing are located between the clamp legs, roll the first girdle down
the legs of the clamp as far as it can go.
The tubing sections will rest against the platform, and the springs will be under the clamp base.
5. Place the second girdle around the upper portion of clamp body (just as the first girdle was initially).
6. Make sure that its spring sections rest against the clamp legs, while its rubber tubing sections sit
against the flask, in between the clamp legs.
4.4 Connecting to mains/power supply
Please read the following warning!
 Only after taking the preceding precautions, plug the power cord into the mains/power supply.
• 1 L and larger flask clamps are fastened with 5 screws.
Description Part No. Quantity Application
10 – 24 × 5/16 in (7.9 mm)
S2116-3051 1 5/16 in (7.9 mm) thick
aluminum, phenolic and
stainless steel platforms.
NOTICE! Risk of damage to the unit!
 The Innova 40/40R Shaker is designed to be operated with a load on the platform.
 Do not operate without a loaded platform.
WARNING! Risk of electric shock and/or damage to unit!
 Check that the voltage and frequency of your unit are compatible with mains/power supply.
 Remove caution label from back of unit.
 Set the circuit breaker on the right side of the unit to the OFF position.
WARNING! Risk of electric shock and/or damage to device!
 Use a grounded power supply.