1 changing displayed parameters, 2 viewing the setpoints, Changing displayed parameters – Eppendorf Innova 40R Shaker User Manual
Page 25: Viewing the setpoints
Operation
New Brunswick Innova 40/40R Shaker
English (EN)
25
5.6.1
Changing displayed parameters
5.6.2
Viewing the setpoints
You can verify the setpoints in the
DISP
screen. The parameter values displayed are the measured values.
The setpoint values are user-selected. They may differ depending on many variables.
1. Turn
Control knob to highlight the parameter you
wish to replace. For this example, we will change
the parameter
RPM
to
HRS
.
2. Press the
Control knob until it clicks.
RPM
will flash.
3. Turn the
Control knob until the desired
parameter appears in the highlighted field.
4. Press the
Control knob to save the parameter.
• If you do not press the
Control knob to save your selection, after a few seconds the screen
will revert to its previous settings.
1. Turn the
Control knob to highlight the actual
(measured) parameter value.
2. Press the
Control knob to display the setpoint.
The setpoint will flash.
3. Click
Control knob in again to return to normal
display.
m
r
i
h
c
s
d
li
B
:
3
.
b
b
A
DISP
m
r
i
h
c
s
d
li
B
:
3
.
b
b
A
DISP
m
r
i
h
c
s
d
li
B
:
3
.
b
b
A
DISP