Connect the speakers and lifestyle, Music center, English setting up – Bose Lifestyle 20 User Manual

Page 9: Connecting the jewel cube, Speakers to the acoustimass, Module, Connecting the acoustimass module to the lifestyle, Figure 4, Figure 5, Customer service

Advertising
background image

AM178934_09_V.pdf

October 29, 2001

7

English

Setting Up

Connect the speakers and Lifestyle

®

music center

Once you have selected locations for your speakers and music center, connect the system.

Connecting the Jewel Cube

TM

speakers to the Acoustimass

®

module

1. Insert the connector of each speaker cable fully into the jack on the rear of each speaker

(Figure 4). Match the ridge of the connector to the notch at the top of the jack.

2. Connect each 20-foot (6.1 m) cable to the corresponding left or right green jack on the

Acoustimass module. Speaker cables have green connectors at one end, with L (left)
and R (right) molded into the connectors.

To lengthen the cable, connect speaker wire with male phono (RCA) plugs on each end to
your supplied speaker cable. Use a female-to-female adapter (“barrel” connector). Or, splice
in 18-gauge (.75 mm

2

) or thicker cord (connecting + to + and – to –). To purchase extension

wire, see your dealer, electronics store, or call Bose

®

customer service.

Connecting the Acoustimass module to the Lifestyle

®

music center

Connect the Acoustimass module to the music center with the audio input cable (Figure 5).

1. Plug the small black multi-pin connector into the jack marked SPEAKER ZONE 1 on the

back of the music center.

2. Insert the right-angle multi-pin connector on the other end of the audio input cable into

the AUDIO INPUT jack on the Acoustimass module. Align the connector at the angle
shown in Figure 5.

Note:

Be sure that each connector is inserted completely into each jack.

3. Extend the audio input cable as much as possible, since it includes an antenna for the

remote control.

For information on connecting zone 2, see “Using two listening zones” on pages 19-20.

CAUTION:
Make sure all components of
your system are unplugged
from the AC power (mains)
source before you begin
connecting them.

Figure 4

Speaker cable connection to the
Jewel Cube speaker

RIGHT

OUTPUTS

TO

CUBE

SPEAKERS

LEFT

AUDIO

INPUT

OFF

POWER

ON

L

R

TAPE IN

L

R

TAPE OUT

Figure 5

Connecting the speakers and the
music center

Right

speaker

R

Left

speaker

L

Power
switch

Right-angle connector

into AUDIO INPUT

Black connector into

SPEAKER ZONE 1

Audio input cable

Power jack

Power jack

Power pack

Advertising