Eppendorf TCA-3 Temperature Monitoring System - Manual (Page 34)

Operation
TCA-3 Temperature Monitoring System
English (EN)
34
4.12.2 Change data range
To view data for specific ranges of values and time:
1. Click on the small arrow at the bottom of the graph to open the manual range selection area.
2. Set the ranges as desired, then press the Reload button.
The Duration of the data displayed on the graph can be changed to Hours, Days, or Months with up to 3
Months of data being displayed on the graph at any one time.
 This can be changed by clicking on the drop down arrows for the Duration times and then clicking on
Reload.
4.12.3 Multiple traces on a graph
It is possible to display more than one trace on a graph for each TCA-3 monitoring system, this could be
used to compare temperature graphs from two different probes.
The graph can display a maximum of 360 data points. When this has been reached there will
be a footnote under the lower right hand side of the graph to signify that the data has been
condensed to fit the screen. Even though the data is condensed it is done so any spikes will be
viewable.