JLG 1500SJ Service Manual - Manual (Page 410)

SECTION 5 - HYDRAULICS
5-58 – JLG Lift – 3121262
Installation
1. Carefully insert the sensor into the cylinder. It may
be necessary to gently tap the end of the sensor to
seat the o-ring into the sensor bore. DO NOT tap on
the wiring harness.
2. Install the cap and secure in place with the retaining
bolts.
3. Apply lubricant JLG P/N 3020039 to the setscrew
and install the setscrew. Torque the setscrew to 4 in.
lbs. (0.45 Nm).
4. Install the plug over the setscrew.
5. Raise the cylinder back in place and install the
retaining pin.
6. Install the keeper pin and retaining bolt.
7. Check the cylinder for proper operation.