JLG 1500SJ Service Manual User Manual
Page 535
Advertising
SECTION 6 - JLG CONTROL SYSTEM
3121262
– JLG Lift –
6-83
14. Once the jib is stopped the screen shown below will
be displayed.
15. Hitting the escape key (ESC) will take the system
back to the initial jib lift calibration display.
NOTE: At this point the left or right arrow key may be used to
skip to any of the other jib sensor calibrations.
16. Hitting the ENTER key at this point will take the oper-
ator to the next jib sensor calibration. The screen will
show:
17. Press Enter. The screen will show:
Advertising